Crossing 3D XL Joystick Heater Repair Kit
If your joystick atomizer has stopped reading, or it throws a no atomizer warning after a cleaning, the heater is almost always the reason. The leads shorten and stop making solid contact, and no amount of fiddling brings that back. A fresh heater with full length leads makes it read right again.
Two options
Full Repair Kit, $20. One ceramic heater with full length leads, the ceramic cup, two silicone gaskets, two ceramic insulators, and two brass pins. That is every wear part in the atomizer, so you are not hunting for anything else once it arrives.
What it fits
The Crossing 3D XL joystick atomizer, the ceramic bottom and side heated bowl that runs on the Core 2.0, the Core XL and the TUG. The joystick atomizer is potted in silicone, so there is nothing inside it to rebuild by hand. These are the repair.
Before you order
If you are getting a no atomizer warning, check the brass pin in the atomizer base first. If it sits a hair too short it will not keep the device’s 510 pin depressed, and that looks exactly like a dead heater. Pull the pin out about a millimetre and try it before you replace anything.










Reviews
There are no reviews yet.