The Divine Crossing Version 5 Rebuildable Concentrate Ceramic Heater is my latest creation
Instructions & Maintenance
Take Immediate Caution: Ceramic heater cups can get up to 600°f and could cause serious burns. Please be careful when handling the unit.
Each part can be replaced, and the whole unit can be rebuilt. There is no need to discard the entire assembly if one part breaks; we designed it with eco-friendly concepts in mind.
The v5 side and bottom heated ceramic cup with vortex airflow can be temperature-controlled, which is the most effective way to conserve and experience concentrates while allowing maximum vapor at the lowest temperatures.
Take note battery/mod settings:
Wattage 27-37w Pulsing button
TCR Value 200 using 36w to get to 500°f
Ultimately, you will want to practice to get the best experience. Some mods produce more power than others at the same settings. To preserve the side and bottom heated ceramic cups, start on a low setting and work your way up to a happy middle ground of flavor and clouds.
How to use:
Always keep your O-rings clean and lubricated with a vegetable oil of your choice. This makes it easier to remove the top. Place a small amount (2-5 hits max) of concentrate into the side and bottom heated ceramic cup. Keep the unit upright throughout the whole session; do not tip or the concentrate will pour out of the cup. Press the button on the mod to start heating the cup and allow the concentrate to boil and vaporize. Now draw slowly; this will allow for maximum vapor and conserve concentrates in the cup from splashing out. Make sure to maintain heat on the cup so that vapor is produced throughout the session. Sessions should not exceed one minute.
Keep the temperatures low enough to avoid burning concentrates to a char (dry).
Always use a Q-tip to clean the cup after each session to maintain cleanliness and performance. Wipe down and clean the glass top while it’s still warm to avoid reclaim buildup in the vapor pathway. Allow the unit to cool down for 3 minutes before the next session.
Installing New Ceramic Heater
Under the right settings, these cups should last a long time. When a ceramic heater cup goes out or the resistance rises, you can replace it by unscrewing two of the screws that keep the cup’s lead wires fastened to the deck. Loosen the screws, then gently pull the cup out and remove it.
Every now and then, you will want to burn off residue on the cup. Set the mod to 38W in wattage mode (this can be less for some mods; always start low and see). Hold it upside down while delivering only two minutes of heat to the cup, then STOP and allow it to completely cool off before the next cleaning session.
Please see the Divine Tribe Youtube Channel for videos with instructions on how to use, clean, and rebuild the unit.
Accessories Compatible with the v5