The Divine Crossing Version 5 Rebuildable Concentrate Ceramic Heater is my latest creation
Instructions & Maintenance
Take Immediate Caution: Ceramic heater cups can get up to 600°f and could cause serious burns. Please be careful when handling the unit.
Each part can be replaced, the whole unit can be rebuilt. There is no need to throw out the whole assembly if one part breaks, we designed this with eco-friendly concepts.
The v5 side and bottom heated ceramic cup with vortex airflow can be temperature controlled. This is the most effective way to conserve and experience concentrates by allowing maximum vapor at the lowest temps.
Take note battery/mod settings:
- Wattage 27-37w Pulsing button
- TCR Value 200 using 36w to get to 500°f
Ultimately you will want to practice for the best experience. Some mods put out more power than others at the same settings. To preserve the side and bottom heated ceramic cups start on a low setting and work your way up to a happy middle ground of flavor and clouds.
How to use:
Always keep your o-rings clean and lubed with a veg oil of your choice. This allows for the easier removal of the top. Place a small amount (2-5 hits max) of concentrate into the side and bottom heated ceramic cup. Keep the unit upright through the whole session, do not tip or concentrate will pour out of the cup. Press button on the mod to start heating the cup, allow concentrates to boil and vapor. Now draw slowly, this will allow for maximum vapor and conserve concentrates in the cup from splashing out. Be sure to maintain heat on the cup so vapor is produced throughout the session. Sessions should be no longer than 1 minute.
Keep temperatures low enough from burning concentrates to a char (dry).
Always q-tip the cup right after each session to maintain cleanliness and performance. Wipe down and clean the glass top while warm to avoid reclaim buildup in the pathway of vapor. Allow 3 minutes for the unit to cool down before the next session.
Installing New Ceramic Heater
Under the right settings these cups should last a long time, when a ceramic heater cup goes out or the resistance rises you can replace it by unscrewing 2 of the screws that keep the cup’s lead wires fastened to the deck. Loosen screws then gently pull the cup out and remove.
Every now and then you will want to burn off residue on the cup. Set the mod to 38w in wattage mode (this can be less for some mods, always start low and see) hold upside down while delivering only two minutes of heat to the cup. STOP allow it to completely cool off before next cleaning session.
Please see the Divine Tribe Youtube Channel for videos with instructions on how to use, clean, and rebuild the unit.
Accessories Compatible with the v5
Steel Vortex Window Top
Glass Vortex Top