XL v5 w/ Pico Plus, Lightning Pen w/ Thunder Cap & Hubble Bubble Bundle

Divine Crossing Collection Bundle

XL v5 w/ Pico Plus, Lightning Pen w/ Thunder Cap & Hubble Bubble 🌊

• 🔥 XL v5 heater: assembled, with the all-metal top installed
• 🌬️ Glass vortex top: one included, so you can run it either way
• 🔋 iStick Pico Plus: with autofire firmware and a Sony VTC6 battery, in your color choice
• 🔌 USB-C cable
• ⚡ Lightning Pen: with Thunder Cap
• 💧 Hubble Bubble water adapter
• 🔑 Keychain dab tool
• 💧 Drip tip: steel tip with your choice of silicone or glass adapter
• 🫙 Stash cap: optional add-on, +$13

• ⚠️ Caution: ceramic heater cups can reach 600°F and may cause serious burns. Handle with care!

• 🌿 Fully rebuildable: swap the one worn part and keep the rest, nothing gets thrown away
• 🌪️ Side and bottom heat: the ceramic cup heats from the side and bottom with vortex airflow, so you get full vapor at lower temps
• 💪 Thicker leads: built to last where heaters usually break
• 🧼 Taller cup walls: less splashing, easier cleanup

• 🌡️ TCR: 200, 36W for 500°F
• ⚡ Wattage: 27 to 37W, pulsing the button
• 🔥 Autofire: double-click to start, single-click to stop
• 🧪 DNA mods: The Vapor Ninja’s settings guide

1. Prep O-Rings: lubricate them with vegetable oil for easy top removal.
2. Load: add 2 to 5 hits max to the XL ceramic cup. Keep it upright.
3. Heat & Vape: double-click for autofire. Draw slowly for max vapor.
4. Keep It Short: limit sessions to 1 minute to avoid burning.
5. Clean Up: Q-tip the cup and glass top while warm.
6. Cool Down: cool for 3 minutes before next use.

• 🔧 Replace the heater cup: unscrew two screws, remove the old cup, insert the new one, then snug the screws once and leave them alone.
• 🧹 Burn-off clean: set your mod to 38W, hold it upside down and heat for 2 minutes. Let it cool completely.
• Clean and maintain: make your heater last a year
• Why set it and forget it works

• 5 clicks: power on and off
• 2 clicks: autofire, hands free for the time you set
• 3 clicks: switch between wattage and M1 TC mode
• Hold power and +: sets the session length, 0 to 60 seconds
• Hold main and −: locks the resistance so a session stays stable
• Hold power and + while off: fine tunes the TCR

• Why this is the best portable dab rig
• Dabbing rosin? See the rosin temperature guide

• XL Heater Cups & Glass Vortex Tops
• XL Steel Top
• Polished XL SiC Insert
• Pico Plus Stash Cap
• Bottomless Banger & Vortex Carb Cap
• iStick Pico Plus with Autofire
• Lightning Pen Heater Cups